Welcome to the What's New News!

 
Here you will find all the latest news of what's happening with the Arcade Restoration Workshop! 
5/9/1999 12:00 AM
Another week of harness making :-) This week I made my Bubble Bobble to JAMMA conversion Harness. That was a chore! Can we say "OVERKILL"? 6 pins of +5, 3 pins of +12, 8 pins of Ground... sheesh! After that was done, I swapped out the TMNT for Bubble Bobble. TMNT is now up for sale (see the For Sale Page) Got my 40pin adapter back from Andromeda Research. Excellent tech support! I would highly recommend them if you are in the market for an excellent EPROM Burner. I can't say enough about these guys. Sanded down the front (or should I say, what I could reach of the front) so now its ready to paint. Probably wont get painted until I get my Air Compressor and Paint Gun (a month or two off). When I have more time, I'll put pictures up of the front of the Metrocross and the Bubble Bobble -> JAMMA converter.

More News!

Below you'll find additional news about what's happening at the Arcade Restoration Workshop!  As you scroll down the page, more news will appear.
2/6/2021 12:29:47 PM
So my Galaga died today...
 
I'm not sure if it's coincidence or related, but I was turning the power off on my Defender by the power switch under the control panel at the exact time it failed. The switch was a bit tough to toggle so it was like in the half way position when it happened. Both games are on the same circuit.
 
8/21/2017 11:10:28 PM
Restoration/Preservation has begun on my Kickman.
 
It's not a full restoration, but more of a preservation of what is there.  I like trying to keep things as original as possible.  With that in mind, I can take a few chances on this one as the damage is already done.  I'm mainly trying to prevent even more damage when I can.  Worse comes to worse, I'll do a full restore on it down the road. 
© Copyright 2009-2025, ClassicSoft, LLC. All rights reserved
Powered by the ClassicSoft Web Content Framework V3