Welcome to the What's New News!

 
Here you will find all the latest news of what's happening with the Arcade Restoration Workshop! 
4/22/2000 12:00 AM

I picked up a Q*Bert board set from Al today for Free. The reason? Well, it appears that someone dropped something sharp and heavy on the PCB because a chip is crushed, an eprom socket is toast, and about 6 traces were obliterated!

I also took a second look at the Cap Kit I did on the Mr Do! Cocktail since the picture wasn't 100%. I found out the Horizontal Width Coil was broke. So I took one off my other GO7 that is broken and used it. Hope Bob Roberts has replacements :-)

More data is up! Slowly but surely. I am trying to get at least one page up a day. Some days I get more up. I will also be reformating pages over time to fit the new page sizes and layout.

More News!

Below you'll find additional news about what's happening at the Arcade Restoration Workshop!  As you scroll down the page, more news will appear.
2/6/2021 12:29:47 PM
So my Galaga died today...
 
I'm not sure if it's coincidence or related, but I was turning the power off on my Defender by the power switch under the control panel at the exact time it failed. The switch was a bit tough to toggle so it was like in the half way position when it happened. Both games are on the same circuit.
 
8/21/2017 11:10:28 PM
Restoration/Preservation has begun on my Kickman.
 
It's not a full restoration, but more of a preservation of what is there.  I like trying to keep things as original as possible.  With that in mind, I can take a few chances on this one as the damage is already done.  I'm mainly trying to prevent even more damage when I can.  Worse comes to worse, I'll do a full restore on it down the road. 
© Copyright 2009-2025, ClassicSoft, LLC. All rights reserved
Powered by the ClassicSoft Web Content Framework V3